Uninstall any and all software with ' DisplayLink' in the title that is present from within the Control Panel -> Programs and Features.Disconnect any DisplayLink powered device from the host computer.If the host computer already has the standard DisplayLink drivers installed, you will want to follow these instructions to install the Hot Desking version: It is recommended that you install these drivers before connecting any DisplayLink device to the host computer as the standard DisplayLink drivers will likely be installed and that will block the install of the Hot Desking compatible version of the drivers. You will need to load the DisplayLink USB Graphics Software for Windows with Hot Desking from the Corporate Installers for Windows section of the DisplayLink downloads page. The standard DisplayLink drivers will not interface with the docking station for recalling the display profiles. Setting up host computers to use the display profiles This process can also be used to overwrite the display profiles stored within a docking station if the display configuration changes. This indicates that the display profile has been saved to the docking station. The displays should disconnect and then reconnect with the print Operation successfulin the Command Prompt window. When the new Command Promptwindow opens, you will want to execute the following command:.Select the option to Run as administrator.Type CMD to show the options for opening a Command Prompt window.From the computer, press the Windows key.Once the docking station and the display settings are set up the way you would like, perform the following steps to save the hot desk profile to the DisplayLink docking station: Use the Display settings to arrange the displays how you will want them to be saved into the docking station profile. To start you will want to connect the computer to the DisplayLink based docking station along with the displays that will be stationed at the hot desk. Saving a display profile to the docking station You will be asked to authenticate this action as the System32 folder requires administrative access.Move the file into the System32 folder typically located at C:\Windows\System32.This is an application that will need to be run in a Command Prompt (CMD) window and executed as an Administrator. You will want to set up one computer that can be used to save or update display profiles using the DockManagementTool.exe application. Setting up to run the DockManagementTool.exe application Can be found as part of the DisplayLink USB Graphics Software for Windows with Hot Desking (9.4 M0) download in the Hot Desk Layout Provisioning folder. Displays to be connected to the docking station.A DisplayLink based device with the following chips installed:.Administrative access to the computer used to set up the DisplayLink docking station.Not available for macOS, Android, Chrome OS, or Linux.A computer with a fully updated version of Windows 7/8.1/10 or later.RequirementsÄŻor this process you will need the following: This article will go over steps needed to program display profiles into DisplayLink based docking stations like the UD-3900C, UD-6950Z, UD-3900Z, UD-6950H, UD-6950, UD-3900H, and UD-3900.
0 Comments
Leave a Reply. |