Displayed audacity5/16/2023 Right-click Windows Start menu and choose Settings from the menu. You can follow the steps below to change the setting. To fix the Audacity error opening sound device, you can change the privacy settings to allow software to access and use the microphone on your computer. Allow Audacity to Use the Microphone on Your PC If you receive the “Error opening sound device” when using Audacity to record sound, you can try the top 3 solutions in this post to fix the error. And normally, it is a permissions issue which may appear after a specific Windows Update, as Windows Update may reset some permissions settings for apps. Well, what causes Audacity “Error opening sound device”? There are various reasons. The Audacity error opening sound device issue usually appears when there are no recording devices available on your computer. How to fix it? This article from MiniTool will show you top three solutions with detailed steps and screenshots. ![]() They are like laptops with only mic-in and headphone-out.When you try to record, play or edit music files with Audacity, you may receive the message “Error opening sound device”. Most audio interfaces have combo XLR/TS/TRS connections so you’ll need adapters or adapter cables.ĭon’t buy a regular “SUB soundcard”. Or, there are lots if higher-end USB audio interfaces with switchable mic-line inputs. The Behringer UCA202 is popular and inexpensive but it doesn’t have a recording-level control. Any suggestion of new hardware - perhaps USB audio input device providing easier to see through and set up recording with Audacity?.But it’s not so terrible if you remember to keep it below -1dB, or so.Īnd the tape machine’s output isn’t clipped, right? That would be unusual. ![]() I assume you know there is no there’s no automatic calibration between 0dB on the tape and 0dBFS (digital).īut if the soundcard doesn’t go all the way to 0dBFS, then it has a defect. I excavated out my old oscilloscope, signal generator and created a 1kHz 0dB test tape. With those things you can’t adjust the analog signal into the built-in ADC so that can’t be fixed either. The same is true if you have a cassette player with USB built-in. If the analog-output from your cassette player is clipping and it doesn’t have a volume control then you can’t fix it (unless you get a different cassette player). ***** It’s a very-minor problem if you know about it and if you can prevent it by lowering the volume. You never told us anything about your hardware setup.Īnd again, there’s no problem with leaving headroom and amplifying digitally after recording… That’s the normal process with digital recording. ![]() ![]() It looks like peaks at -3dB or less would be OK. That’s just something you’ll have to try (if you can adjust the analog level). It LOOKS like there’s something wrong with your hardware* but you may be able to prevent the clipping by lowering the level. Or you can import an MP3 or floating-point WAV that goes over 0dB without clipping and Audacity will show red. You can import a clipped digital recording and it won’t show clipping if it’s clipped below 0dB. It doesn’t know if your preamp (or other analog circuitry) clipped while recording or if clipping occurred somewhere else. It’s just looking at the digital amplitude and showing POTENTIAL clipping. I already answered that here in a reply to your other post.
0 Comments
Leave a Reply. |